200-125 Dumps 200-125 Exam Questions 200-125 New Questions 200-125 PDF 200-125 VCE Cisco

[Full Version] Ensure Pass 200-125 Exam By Training Lead2pass New PDF Dumps (584-594)

2017 February Cisco Official New Released 200-125 Dumps in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

Lead2pass updates Cisco 200-125 exam questions, adds some new changed questions from Cisco Official Exam Center. Want to know 2017 200-125 exam test points? Download the following free Lead2pass latest exam questions today!

Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/200-125.html

QUESTION 584
Refer to the exhibit. You have discovered that computers on the 192 168 10 0/24 network can ping their default gateway, but they cannot connect to any resources on a remote network.
Which reason for the problem is most likely true?

A.    The 192.168.12 0/24 network is missing from OSPF
B.    The OSPF process ID is incorrect
C.    The OSPF area number is incorrect.
D.    An ARP table entry is missing for 192.168.10.0.
E.    A VLAN number is incorrect for 192.168.10.0.

Answer: C

QUESTION 585
If three devices are plugged into one port on a switch and two devices are plugged into a different port, how many collision domains are on the switch?

A.    2
B.    4
C.    5
D.    6

Answer: B

QUESTION 586
Which three commands must you enter to create a trunk that allows VLAN 20? (Choose three)

A.    Switch(config-if)#switchport mode dynamic auto
B.    Switch(config-if)#switchport mode trunk
C.    Switch(config-if)#switchport trunk allowed vlan 20
D.    Switch(config-if)#switchport mode dynamic desirable
E.    Switch(config-if)#switchport trunk encapsulation dotlq
F.    Switch(config-if)#switchport trunk native vlan 20

Answer: BEF

QUESTION 587
Which two statements about Ethernet standards are true? (Choose two)

A.    Ethernet is defined by IEEE standard 802.2.
B.    Ethernet is defined by IEEE standard 802.3.
C.    Ethernet 10BASE-T does not support full-duplex.
D.    When an Ethernet network uses CSMA/CD, it terminates transmission as soon as a collision occurs.
E.    When an Ethernet network uses CSMA/CA. it terminates transmission as soon as a collision occurs.

Answer: BD

QUESTION 588
Which three options are types of Layer 2 network attack? (Choose three.)

A.    ARP attacks
B.    brute force attacks
C.    spoofing attacks
D.    DDOS attacks
E.    VLAN hopping
F.    botnet attacks

Answer: ACE

QUESTION 589
Which three statements about DTP are true? (Choose three.)

A.    It is enabled by default.
B.    It is a universal protocol.
C.    It is a proprietary protocol.
D.    It is disabled by default.
E.    It is a Layer 3-based protocol.
F.    It is a Layer 2-based protocol.

Answer: ACF

QUESTION 590
How does a router handle an incoming packet whose destination network is missing from the Routing table?

A.    it discards the packet.
B.    it broadcasts the packet to each network on the router.
C.    it routes the packet to the default route.
D.    it broadcasts the packet to each interface on the router.

Answer: A

QUESTION 591
If you configure syslog messages without specifying the logging trap level, which log messages will the router send?

A.    error conditions only
B.    warning and error conditions only
C.    normal but significant conditions only
D.    all levels except debugging
E.    informational messages only

Answer: E

QUESTION 592
Which feature facilitates the tagging of frames on a specific VLAN?

A.    Routing
B.    hairpinning
C.    switching
D.    encapsulation

Answer: D

QUESTION 593
Which WAN topology provides a direct connection from each site to all other sites on the network?

A.    single-homed
B.    full mesh
C.    point-to-point
D.    hub-and-spoke

Answer: B

QUESTION 594
Which two options are primary responsibilities of the APIC-EM controller? (Choose two.)

A.    It automates network actions between different device types.
B.    It provides robust asset management.
C.    It tracks license usage and Cisco IOS versions.
D.    It automates network actions between legacy equipment.
E.    It makes network functions programmable.

Answer: AE

Lead2pass promise that all 200-125 exam questions are the latest updated, we aim to provide latest and guaranteed questions for all certifications. You just need to be braved in trying then we will help you arrange all later things! 100% pass all exams you want or full money back! Do you want to have a try on passing SK0-004?

200-125 new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDRlZYdkxpZUE0VnM

2017 Cisco 200-125 exam dumps (All 623 Q&As) from Lead2pass:

http://www.lead2pass.com/200-125.html [100% Exam Pass Guaranteed]